I'm not sure it the article from Bicycling of September 2014 is acurate but it states:
According to European cycling tradition, climbs fall into four categories based on their difficculty; a fifth, hors (above category),
is reserved for the most difficult routes. Here'S the breakdown CAT 4 ' "These easier Climbs have average grades of 2 to 3 percent over 3 miles, or up
to 5 percent for climbs shorter than a mile CAT 3 Climbs with rates that average less than 5 percent over 6 miles or much shorter ascents up to
10 percent CAT 2 Ascents up to 4 percent over 9 miles or with an 8-percent grade over 3 miles CAT 1 Climbs up to 12 miles long at 5 percent or 5-mile
pitches at up 8 percent HORS CATÉGORIE Average grades of 7 percent over at least 6 miles or 6-percent grades that span 15 miles or more—C.J.
Hi Marcos - I don't know how grand tour Climb Categories are worked out, but these are the rules that we use...
To work out the Category of a climb, we multiply the length of the climb in metres by the gradient of the climb in percent to determine a score. This score is then used to determine the Category as follows:
For example, a climb that goes on for 1km at an average gradient of 12.5% has a score of 1000 x 12.5 = 12500, which equates to Category 4.
Is your method of determine Climb Categories the same as used in the grand tours as in France, Italy and Spain?
Awesome update! Thank you!
Labels you add to the route (via the Directions) will be shown on the route profile tool, but labels added off-route (via the Annotate Map tool) won't be as they are not attached to points on the route.
Mhhh, I think I found it: So labels are not shown, but "directions" are shown...
I think this is a great new feature. Thanks for this!
The only thing I didn't find out yet is how to create labels that are saved permanently. When "annotating" the map in the route editor those labels are not shown in the route profile tool. I think that's not a surprise as they can be positioned absolutely free on the map. So perhaps my exact question is: How to create labels ON the route in the route editor...
Perhaps you can help me...
AH, brilliant! Thanks!
If you want to permenently save labels on the route profile, it is best to add them to the route itself in the route planner, than they will be automatcially loaded in the route profile tool. However, you can reload the route profile with all the settings you chose, including the range sliders, smooting etc by selecting SHARE and saving a copy of the link provided. This link will reload the route profile with all the settings you chose.
Is there a way to save the customizations? After customizing, all, except the color choices, is erased when I leave the area and come back to it.