Shift Route to Side of Road Followed By Replot Section BugFORUMS HOME SEARCH FORUMS

Thanks Andy, we'll get that fixed.

Hi,

Spotted another slight issue.

When using the "Shift Route to Side of Road" the "After Edit" indicator of the distance is updated to reflect the new length of the route. However if you "confirm" the edit - current length indicator is not updated with the new length. If you subsequently add a new point and then perform an "undo" operation the current length "undoes" to the correct (modified) length. So I think the route length is known to be the "new" length its just that the indicator is not updated to the new length after the "confirm" is selected. 

Thanks for your quck response. I've given it a quick try and, as you said, it looks like it is fixed.

Thanks again.

Thanks for flagging that up Andy and for the very helpful steps to reproduce the problem. We've found the bug and have put in a fix, so hopefully it should be working OK now.

Hi,

Thanks for the new featiure of "Shift Route to Side of Road" - very useful for routes with crossing paths and loops. I believe you have also enhanced this to add the ability to shift part of a route using a section mechanisusm but I think this addition has had a negative effect on other tools.

For example perform the following

1. Create a simple route 
2. Use the new "Shift Route to Side of Road" to move the route slightly and confirm this action. No need to use the selection buttons to mark start/end of shift but they do appear on desktop site when doing this action.
3. Immediately afterwards try using the "Replot Section" tool. In this tool try using the start/end markers to select a section. You will notice that the markers become swappped and location becomes erractic, also the slide bars at the bottom left of the map area do not appear so you cannot move the start/end markers accept by selecting them (you can also move them anywhere - even not on the route!). If you cancel this action without confirming it you will also note that the route is lost (try adding another point).

You can perform and "undo" to recover the route. However even after doing this and clearing the route from the page the replot function does not work. A forced reload of the page is required to fix the issue. 

Let me know if you need any further information.